The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

cjwilson99 · 12-23-2002, 05:32 PM

I have a 71 Chevy SWB with coil rear. I need to replace all 4 springs. They are worn out bad. I want to do a 2/4 drop.

My question is: If i get 2 inch drop spindles for the front, do I get stock springs? Or do I still get 2 inch drop springs? Would both the drop spindles and springs lower the front 4 inches. I want to do it right and not have any oversteering problems.

My plan for the rear was 4 inch drop springs in the back and then get an adjustable Panhard bar, and then get 2 inch drop spindles and stock springs for the front. Will this work?

12-23-2002, 05:32 PM	#9
cjwilson99 Registered User Join Date: Feb 2002 Location: Conroe, TX Posts: 16	another lowering question I have a 71 Chevy SWB with coil rear. I need to replace all 4 springs. They are worn out bad. I want to do a 2/4 drop. My question is: If i get 2 inch drop spindles for the front, do I get stock springs? Or do I still get 2 inch drop springs? Would both the drop spindles and springs lower the front 4 inches. I want to do it right and not have any oversteering problems. My plan for the rear was 4 inch drop springs in the back and then get an adjustable Panhard bar, and then get 2 inch drop spindles and stock springs for the front. Will this work?