The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - flywheel question- one piece seal vs. two piece seal.

**crossy** · 08-26-2007, 09:14 AM

sorry, guys but i have swapped WAY TOO MANY engines and manifolds to remember which way is which. i merely said CHECK IT OUT before you commit. you can do it while the engine is still on the ground or stand.
I only have one stock chevy small block truck here right now and it's an 81 and I've said many times DO NOT use an 81 to compare anything because they are a cross over year and MANY parts are similar to 1980 NOT 1982. crossy

08-26-2007, 09:14 AM	#11
crossy Oh,you can't buy that new Join Date: Apr 2000 Location: Pennsville,N.J. 08070, USA Posts: 2,042	Re: flywheel question- one piece seal vs. two piece seal. sorry, guys but i have swapped WAY TOO MANY engines and manifolds to remember which way is which. i merely said CHECK IT OUT before you commit. you can do it while the engine is still on the ground or stand. I only have one stock chevy small block truck here right now and it's an 81 and I've said many times DO NOT use an 81 to compare anything because they are a cross over year and MANY parts are similar to 1980 NOT 1982. crossy __________________ "been there, done that, ruined the T-shirt". 2007 LBZ GMC Sierra, ECSB 2006 LM7 RCSB Silverado 98 Vortec project. 94,3500,6.5L 4L80 81 SWB GMC POS finally gone 73 Pinto, stock, w/CragarSS's-eww 84,C10 SWB-Yella,stock 86 K10 SWB-Red, hopped up 305,4/S LOTS of Cummins trucks.