The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

prg machine · 08-26-2007, 09:09 PM

I have an excellent transplated long fleet bed on a K-20 that the PO found and put on the truck. What I need are pictures if possible and perhaps a measurement here or there.
The supports I am refering to are at the lower side of bed adjacent to the wheel well openings. There are holes down there but nothing is attatched. Kinda like the bed wasn't totaly finished. I am assuming they are like a 5/16 or 3/8 rod from the point I describe to somewhere on the frame to keep the lower sheetmetal from flapping in the breeze.

Any help would be great. I can fab it all up without any problem.

Thank you

08-26-2007, 09:09 PM	#1
prg machine Registered User Join Date: Jun 2007 Location: oregon Posts: 1,069	Bed side lower supports for Fleet side I have an excellent transplated long fleet bed on a K-20 that the PO found and put on the truck. What I need are pictures if possible and perhaps a measurement here or there. The supports I am refering to are at the lower side of bed adjacent to the wheel well openings. There are holes down there but nothing is attatched. Kinda like the bed wasn't totaly finished. I am assuming they are like a 5/16 or 3/8 rod from the point I describe to somewhere on the frame to keep the lower sheetmetal from flapping in the breeze. Any help would be great. I can fab it all up without any problem. Thank you