The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Aarons72s · 09-13-2007, 01:09 AM

I am getting ready to clean up my brake booster for the orange and white and I noticed the push rod coming out the front was crooked. I was able to pullit and the gasket out the front with little effort. My question is should it have done that? Which I think the answer is no. And if so should I glue the gasket back in place where it belongs. Also what would be a good grease to use to lube the rod. As it has some grease on it from the factory but looks pretty dried out. Thinking of using some disk brake caliper pin grease. Thanks.

09-13-2007, 01:09 AM	#1
Aarons72s Registered User Join Date: Apr 2006 Location: oklahoma Posts: 10,669	brake booster question I am getting ready to clean up my brake booster for the orange and white and I noticed the push rod coming out the front was crooked. I was able to pullit and the gasket out the front with little effort. My question is should it have done that? Which I think the answer is no. And if so should I glue the gasket back in place where it belongs. Also what would be a good grease to use to lube the rod. As it has some grease on it from the factory but looks pretty dried out. Thinking of using some disk brake caliper pin grease. Thanks. Last edited by Aarons72s; 12-02-2008 at 11:07 PM.