[glock35ipsc]

Well, this weekend ensured that it will happen sooner! I finally got the bottom piece of the dash cut out and tacked in place. Since I cut the entire center out, I had a gap along the bottom side of the dash. I decided that instead of just cutting a piece to fill in the gap, I would weld a piece all the way across. This also helped to fix the problem off the bottom piece being so beat up that it waved back at you!

Also got both front fenders completely sanded inside and out, the spot welds on the ends and one shipping ding in the tailgate fixed, and started sanding on the drivers door. Need to pull the drivers door and finish sanding it, finish sanding the hood, and the inside of the bed. Then I can break out the primer!

As far as the cab goes, I just need to finishing placing some more tacks welds on the dash, seam seal the rest, and it's ready to prime also. Oh, and most important, cut out glove box!!!!