The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

rfmaster · 10-14-2007, 03:46 PM

Duro'

If you look at full res photos you'll find a 3/8" hose going from left side all the way across toward frame rails to the right. I know, it is tough to see it on the left side, but it is clearly visible on the right side of the photo - running parallel to the brake line. At one end it taps into dif housing above oil level. Breather end has special plastic valve-breather to keep external moisture from getting in. Since I am not original owner I do know when this mod was performed.

Not a good answer - aghh??

//RF

10-14-2007, 03:46 PM	#17
rfmaster Registered User Join Date: Oct 2003 Location: OC CA Posts: 1,374	Re: Aluminum Diff Covers Duro' If you look at full res photos you'll find a 3/8" hose going from left side all the way across toward frame rails to the right. I know, it is tough to see it on the left side, but it is clearly visible on the right side of the photo - running parallel to the brake line. At one end it taps into dif housing above oil level. Breather end has special plastic valve-breather to keep external moisture from getting in. Since I am not original owner I do know when this mod was performed. Not a good answer - aghh?? //RF __________________ "The Beast" 1975 Chevrolet C20 longbed 350/700R4! with 3inch body lift Dual Flowmasters Super 40's! TBI retrofit completed (2007-07-29) New 383CID (+030) 08-304-8 9.5:1CR x36,005 (2012-12-17)