|
Re: I couldn't take it anymore (rollbar)
Quote:
Originally Posted by bouncytruck
Couldn't you do a "skin" around a conventional roll bar.
|
You could, but I was thinking the ease of bending sheet metal as opposed to a pipe bender. Plus I could tie it into my 'B' post and support the bottom to my frame. Kinda like tranmitting the load all the way down and to my frame. I think present day technology says .125 wall thickness
Ther was a guy over on CK5, that went into theory of a round pipe as opposed to a square, short version, round handles side impact better than square
This guy lost me after the first post, heavy heavy stuff. This guy is a genius, so who am I to question his thoughts
__________________
Semper Fi...Uncle Sam, you da man
All parts offered to help are free, unless otherwise noted
Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST
AS usual, off topic
They say your mind goes second, can't remember the first
Jim
Last edited by jaros44sr; 10-17-2007 at 07:38 PM.
|