|
Re: Electric Choke Wiring, Smartest way?
Quote:
Originally Posted by Husker
If you are running an HEI just use your old coil wire.
Ron
|
The electric choke needs a full 12 volts to operate properly. The old coil wires have a built in resistance to reduce voltage to 9 volts to protect the coil windings. A common source often used for the choke wiring is the hot wire to the wiper motor. Any key on 12 volt source is good but I would run a fuse in the circuit.
__________________
VetteVet
metallic green 67 stepside
74 corvette convertible
1965 Harley sportster
1995 Harley wide glide
Growing old is hell, but it beats the alternative.
|