The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

badriand · 11-06-2007, 10:15 PM

2 or 3 screws that hold the channel for the vent window on the top side of door and 2 screws on the panel toward the bottom middle remove those then slide the vent window out. I got my window out by rolling it up halfway then pulling the window up and over so the roller on the right side slid out then rolled the back one out. Next pull out. O yea easier if you remove the molding and felt also, felt has little tabs that hold it in place. Patience is your friend here.

11-06-2007, 10:15 PM	#4
badriand Registered User Join Date: Sep 2007 Location: east texas Posts: 463	Re: Window Removal... 2 or 3 screws that hold the channel for the vent window on the top side of door and 2 screws on the panel toward the bottom middle remove those then slide the vent window out. I got my window out by rolling it up halfway then pulling the window up and over so the roller on the right side slid out then rolled the back one out. Next pull out. O yea easier if you remove the molding and felt also, felt has little tabs that hold it in place. Patience is your friend here.