The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

bulldozer · 11-08-2007, 10:53 PM

I just removed the drive shaft from my truck to replace the carrier support and bearing. I removed the back half of the shaft . do I need a bearing puller to remove the old bearing and cut the ruber remains from the old support?
I am open to you suggestions. I dont remember using a bearing puller or any special tooling when I had my 58' Belair 2 peice shaft. Am I losing my mind.

11-08-2007, 10:53 PM	#1
bulldozer Registered User Join Date: Apr 2006 Location: Lincoln Ca. Posts: 6	72 Longbed Drive Shaft I just removed the drive shaft from my truck to replace the carrier support and bearing. I removed the back half of the shaft . do I need a bearing puller to remove the old bearing and cut the ruber remains from the old support? I am open to you suggestions. I dont remember using a bearing puller or any special tooling when I had my 58' Belair 2 peice shaft. Am I losing my mind.