The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

1969k10stepside · 11-11-2007, 07:39 PM

Well,I went out,and put the new springs in one side and left the old one in the other side..this was to see if there was a difference between the 2.I get it all back together,get out the tape measure and measure off the same point on both sides..and guess what? They are the same!! You know what that means? These still won't work.Sure,they may be new springs but the truck will sit the same as it did before...I guess I'll call them again tomorrow

I guess I'll ask for 6" front springs tomorrow and see what happens then...
B@$terd$

If I wasn't putting the lift on myself,I'd send them a bill for labor costs..hmm,I might still do that

11-11-2007, 07:39 PM	#10
1969k10stepside Registered User Join Date: Mar 2006 Location: USA Posts: 21,019	Re: Lift kit install #2 Well,I went out,and put the new springs in one side and left the old one in the other side..this was to see if there was a difference between the 2.I get it all back together,get out the tape measure and measure off the same point on both sides..and guess what? They are the same!! You know what that means? These still won't work.Sure,they may be new springs but the truck will sit the same as it did before...I guess I'll call them again tomorrow I guess I'll ask for 6" front springs tomorrow and see what happens then... B@$terd$ If I wasn't putting the lift on myself,I'd send them a bill for labor costs..hmm,I might still do that Last edited by 1969k10stepside; 11-11-2007 at 07:40 PM.