The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jaros44sr · 11-12-2007, 07:11 AM

Not much, but a little progress is better than no progress!!

I'm glad that I continued to take off more brackets as the one at the rear of the drivers seat was really rusted and would continue to do so, if I hadn't stopped it, hopefully...

There are 3 spot welds holding this pc. on, and I missed 2, so I riped my floorboard up alittle, and I cut to deep...

Bracket is off, all I have to do is some wire wheeling, zinc prime and some welding...
Be careful of those little wires on your wheel, one flew off and hit me in the groin, man did that hurt!!!

11-12-2007, 07:11 AM	#260
jaros44sr Registered User Join Date: May 2006 Location: Philadelphia, Pa. 19454 Posts: 9,435	Re: PO has me PO'd Not much, but a little progress is better than no progress!! I'm glad that I continued to take off more brackets as the one at the rear of the drivers seat was really rusted and would continue to do so, if I hadn't stopped it, hopefully... There are 3 spot welds holding this pc. on, and I missed 2, so I riped my floorboard up alittle, and I cut to deep... Bracket is off, all I have to do is some wire wheeling, zinc prime and some welding... Be careful of those little wires on your wheel, one flew off and hit me in the groin, man did that hurt!!! __________________ Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim Last edited by jaros44sr; 11-12-2007 at 07:24 AM.