[k-nuts]

I'm no expert by any means. My truck has a set of the other seats in it. It was supposed to have Utility Buckets. If you bolt my current seats to the front bolt holes, then the rear ones do not line up. Same on both sides. (the PO rigged them up a bit to work) The bolt holes for the "pin release thing" on the passenger side on my truck are off set towards the passenger door. Most all the seats I've seen have that release bracket right in the center. I think the trucks with the later or maybe CST seats have bolt holes for both types of seats. Again, I'm no expert just poking around a little before I start to restore mine. I had a post about my seats on here before. I think I want to go the original look on my resto so I'd like a set of the metal back utility buckets and them have them redone to at least look close to original material.