View Single Post
Old 12-30-2007, 08:08 AM   #4
04Xrider
Registered thread killer
 
04Xrider's Avatar
 
Join Date: Nov 2006
Location: Cookson, OK.
Posts: 349
Re: I need power conversion info

I believe you can use anything from 67-83, and then the later ones use a o ring seal instead of a compression seal, my setup is from a 87, with the exception of the bracket. The one thing to keep in mind will be the power steering bracket. If you have a long nose or short nose water pump, you will need the right bracket to work with it. I bought a used setup from a salvage, and used them for cores at auto zone, but only after I found that the gearbox was junk. I also used a double ujoint at the end of the steering shaft because the rez kit pushes the box out of alignment with the steering shaft, and I did not like that.
__________________
!966 stepside, 350 SB, ZZ-4 roller, Crane roller rockers, 0.030 flat tops, airgap intake, 750 Holley, stainless steel headers, edelbrock SDT mufflers, Mark 8 elec fan, 700R-4, column shift
04Xrider is offline   Reply With Quote