The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

68 short step · 01-06-2008, 04:28 PM

i tried this, i own a 76 firebird..and yes with a taper balljoint reamer they would fit, but they dont have the stops like the truck spindles do.....also i beleive the bearings are diffrent, so you'ld have to run a second gen. rotor ( this means converting from a 5on5 bolt pattern to a 5 on 4 3/4)
IMO just buy a set of 2.5 drop spindles for your truck for about 250 shipped..

01-06-2008, 04:28 PM	#3
68 short step Senior Member Join Date: Aug 2005 Location: tulsa OK Posts: 3,070	Re: 2nd Gen Camaro spindles for Lowering? i tried this, i own a 76 firebird..and yes with a taper balljoint reamer they would fit, but they dont have the stops like the truck spindles do.....also i beleive the bearings are diffrent, so you'ld have to run a second gen. rotor ( this means converting from a 5on5 bolt pattern to a 5 on 4 3/4) IMO just buy a set of 2.5 drop spindles for your truck for about 250 shipped.. Last edited by 68 short step; 01-06-2008 at 04:29 PM.