Yes, the sb will bolt in on the 6/250 stands. the HEI will fit, but is tight .......I can remove/replace the dist with the cap & rotor off. I used the 73 up water pump, steering pump,brackets & pulleys to get the fan proper distance with the shroud without a bunch of spacer. On the clutch linkage, I used the V8 pcs, but with a couple mods. I used a screw in pivot ball, in the foward hole in the block, & set the bellcrank up perpendicular to the block, & redrilled the holes for the frame bracket. the bottom rod was also adjusted for lenght. Set up like this, a set of 69090 headmans fit & cleared the linkage. Im not sure about header clearance on the bell crossmember, as my truck was an auto converted to stick(pretty sure they will go tho). Good luck, crazyL 
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....
|