The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

bagged01extcab · 01-22-2008, 10:51 AM

At this point I still needed to setup the rack & pinion, but moved on to the back in order to get a "rolling" chassis. The first thing I did was to remove all of the old crossmembers and brackets. I then put in a piece of 2x4 tube across the back of the frame and built my own notches also out of 2x4 tube. Once I installed the notches, I boxed in most of the rear frame rails.

01-22-2008, 10:51 AM	#14
bagged01extcab Registered User Join Date: Jun 2004 Location: Longview tx Posts: 270	Re: rocker+22's=? At this point I still needed to setup the rack & pinion, but moved on to the back in order to get a "rolling" chassis. The first thing I did was to remove all of the old crossmembers and brackets. I then put in a piece of 2x4 tube across the back of the frame and built my own notches also out of 2x4 tube. Once I installed the notches, I boxed in most of the rear frame rails. __________________ Trey Oney Last edited by bagged01extcab; 01-22-2008 at 11:25 AM.