|
Re: Big Block Motor Mount Question...?
67 CST if you use the small block stands the trans linkage will not line up. Also small block stands would require over 1/2 of the top of the stand to be cut away for the headers to fit. Have you looked at the performance online tubular mounts? If you use the BB stands I have a 1 piece driveshaft the correct length w/1330 yoke and Ujoints complete.I put a new 1350 Dennys nitrous ready in my '72 a few months back.
http://www.performanceonline.com/sto...cat=455&page=1
__________________
'72 SWB 3,600# Indigo Blue , Sunset Racing Pump Gas 582" 1,002hp / 833tq ,Transking 400 W/ Transbrake, Moser Dana 60 w/4.30
Old Motor: 60'. 1.43
1/8 6.58@104.64
1/4. 10.42@127.10
Nitrous: 60'. 1.28
1/8. 6.15@ 112.02
1/4. 9.75@ 136.32
Last edited by RICKSRAT; 01-30-2008 at 04:18 PM.
|