Thread
:
project INCREDIBLE HULK 6.2L with 6L80E
View Single Post
02-12-2008, 12:54 PM
#
79
68 short step
Senior Member
Join Date: Aug 2005
Location: tulsa OK
Posts: 3,070
Re: project INCREDIBLE HULK
got the driver side inner rocker pnl welded in,and cab support...hung the door to align the outter rocker only to descover the front bottom of the door hit the inner rocker, near the front curve of the angle of the rocker....after wondering why it was doing that and some measuring, i descovered that the ' curve' wasnt the same contour as the bottom of the door, and it also tapered up where i cut it.. futher adding to why it interferred with the door...so i cut out the angle of the rocker and made it so it didnt taper up, and re shaped the curve to match the bottom of the door.....
68 short step
View Public Profile
Find More Posts by 68 short step