View Single Post
Old 02-19-2008, 11:12 AM   #3
87Lowrider
Navy Radioman Veteran
 
87Lowrider's Avatar
 
Join Date: Jul 2007
Location: Western Kentucky
Posts: 1,356
Re: bein ken didnt get to it What did you get done 2/17/08

I tore down the 454 to get it ready for the rebuild. Atleast the top end anyways, assuming rotating assy is ok. Block is virgin 2 bolt. Here's a few pics.

Before pressure washing


After


1976 3/4 ton 454 361959, found the truck in a barn. Drove it into the garage & pulled the motor and TH400.


781 Heads.. going to Louisville on Friday for 7angle and new 2.190s/1.880s and all the trimmings. (Brother is a machinist) - Cuts down on laborcosts


And to top it off Friday, some of my parts started to "flow" in.

7561 RPM Air-Gap Intake
1407 CARB
Comp Cams XE274H-10 552/286
Comp Cams Timing Set

Lots of work to do before spring... Kenny
87Lowrider is offline   Reply With Quote