View Single Post
Old 02-22-2008, 09:57 PM   #8
crazy longhorn
Fabricate till you "puke"
 
Join Date: Jun 2002
Location: Ill
Posts: 9,402
Re: 9-inch Fab - need perch distance

Why not build a welding fixture, that fits the saddles of the stock rear(pinned to the pads on ea side? Lay it down on the welding table, set the new perches in place, set the new axle in place /center/ set pinion angle & weldb crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....
crazy longhorn is offline   Reply With Quote