The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Keno · 02-27-2008, 04:24 AM

Thanks everyone for your replies. I took the last one back today and had an older gentleman wait on me, here's the one you need try 2 full shims and 2 half shims on the outside bolt and see if that don't get it. B-A-M !!! Thank GOD for older guys that know their stuff it's quiet as all get out too.... this one did come with the instructions on shimming with the 1/8 in. rod and not the oldstyle between the gears .20mm crap. That's something else the older guy said the instructions that had been with these starter are wrong they are for the mid 60's model that bolted up differently.

Thanks again!!!

02-27-2008, 04:24 AM	#15
Keno Registered User Join Date: Feb 2008 Location: Owasso, OK Posts: 4	Re: 1971 C10 starter issues Thanks everyone for your replies. I took the last one back today and had an older gentleman wait on me, here's the one you need try 2 full shims and 2 half shims on the outside bolt and see if that don't get it. B-A-M !!! Thank GOD for older guys that know their stuff it's quiet as all get out too.... this one did come with the instructions on shimming with the 1/8 in. rod and not the oldstyle between the gears .20mm crap. That's something else the older guy said the instructions that had been with these starter are wrong they are for the mid 60's model that bolted up differently. Thanks again!!!