The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - '67 step-side replacement rear bumper

Richard8971 · 03-17-2008, 06:26 AM

The brake lines from the master cylinder to the proportioning valve had to be remade because the fittings on my stock valve wouldn't fit into the S-10 unit.

Discovered something else fun today. Now my shift lever on the column hits the booster and won't allow it to go into park. Hmmmmm.... I didn't realize that it was going to be a problem. The steering column had to be taken out so I could get the booster bolted in...

Back to the drawing board...

D

Hey, did I mention that the truck runs???

03-17-2008, 06:26 AM	#154
Richard8971 Still livin the "dream" in '54 Join Date: Nov 2006 Location: Tucson, AZ Posts: 2,656	Re: '67 step-side replacement rear bumper The brake lines from the master cylinder to the proportioning valve had to be remade because the fittings on my stock valve wouldn't fit into the S-10 unit. Discovered something else fun today. Now my shift lever on the column hits the booster and won't allow it to go into park. Hmmmmm.... I didn't realize that it was going to be a problem. The steering column had to be taken out so I could get the booster bolted in... Back to the drawing board... D Hey, did I mention that the truck runs??? Attached Images __________________ Current build. 1954 Chevrolet 3800 "Ella" SOLD! My '67 stepper "Tangerine Dream" "Anything worth doing is worth doing right" James Dean “When you have eliminated all which is impossible, then whatever remains, however improbable, must be the truth.” Sherlock Holmes "There is no spoon." Neo Last edited by Richard8971; 03-17-2008 at 06:32 AM.