View Single Post
Old 04-02-2008, 07:52 AM   #82
Rokcrln
Senior Member
 
Rokcrln's Avatar
 
Join Date: Jul 2005
Location: Winters Ca. 95694
Posts: 4,843
Re: [Project] "Fnlow69" PART II

Quote:
Originally Posted by grendel View Post
looks like a rock crawler built it
Hey I resemble that remark

Your progress is looking great! One question for you. On your rear bag mounts are you going to add any more bracing? What you have so far looks sweet but all three points are almost in the same plane and that will not give you alot of upward support. I would at least place a small piece ot tube from the top of frame right up to the front bar and this will help act as a lerverage point for the bag mount and apply the force to the drive shaft hoop. Ifyou already had plans for more braces then never mind my rambling

*Oop's* I posted this with out seeing their was a page 4!! I see that you changed the locations of the mount tubes, with the front one so close to the frame will it add much suport or is it solid as is?


Kevin
LFD Inc.

Last edited by Rokcrln; 04-02-2008 at 08:00 AM.
Rokcrln is offline   Reply With Quote