Quote:
Originally Posted by protrash64
Is that the finished gauge panel in the truck?? Looks cool if it is.........are you building a hybrid low-high hump tranny cover? Good looking project.
|
It is not, that was the original, the finished panel is digital. It is a low hump I believe (shift was originally on floor I think, although the original column had shift linkage on it as well). Just missing that front piece but it will all be fixed when I do the interior.
Quote:
Originally Posted by Dadsredwagon
looks to be lowered , what did you do to lower it?
|
2.5 inch dropped spindles in front and 5 inch drop springs in rear. very drivable but a few high - speedbumps get the exhaust a bit.
Next up is major steam clean, then moving the fuel tank to the rear and possibly putting a wood bed in it (has sheets of plywood now, although it makes for easy access
)
after that Interior - exterior I like the way it is, although my kids keep telling me to paint it.
Then the engine compartment and air. Air could be sooner than later because I live in vegas!
Steven