|
Re: Vaccuum Gage not working
I feel kinda dumb...................I checked the obvious today, removed the gauge and looked in the opening behind the fitting on the back of gauge. I found a small screw valve in it. I turned it open 90* sucked on it holding it up to a mirror and it works fine!!!!!! I have no idea what the screw is. All I know is i love the fact this cool looking gauge is now working!!!! Timing and what not is off indicating low vacuum and all of the fittings to gauge are just finger tight as well. I was excited and wanted to take a picture so here it is!!!
__________________
69 K-20 cloned to a 67 with front clip and some other stuff.
383 .040 over
Crane roller cam lifters and rockers ,1.6 intake ratio, Open chamber heads, 9.5-1 compression ratio, 2.02 intake valves , Edelbrock performer Air Gap manifold Carter AFB performer 750cfm, MSD ignition, SM465 NP205 4.10 gears: 
|