The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

piecesparts · 05-11-2008, 02:47 AM

Are you talking about the foam backed headliner material install? If so, then you can get away with a quart or two of just plain old Contact Cement and a cheapo spray gun from Wally Mart. Set the settings on the gun to spray a very thick trace and spray both the foam backing and the surface that you are mounting it to. let set for a few minutes and then stick material to surface. DO NOT OVERSPRAY or glue will soak through the material. It will come out looking like a buch of ribbons and not a spray paint coating. I have done it many times. Clean the gun with a lacquer thinner.

05-11-2008, 02:47 AM	#3
piecesparts Parts and more parts Join Date: Nov 2003 Location: Lebo, Kansas (middle of nowhere Posts: 6,821	Re: Which 3M glue? Are you talking about the foam backed headliner material install? If so, then you can get away with a quart or two of just plain old Contact Cement and a cheapo spray gun from Wally Mart. Set the settings on the gun to spray a very thick trace and spray both the foam backing and the surface that you are mounting it to. let set for a few minutes and then stick material to surface. DO NOT OVERSPRAY or glue will soak through the material. It will come out looking like a buch of ribbons and not a spray paint coating. I have done it many times. Clean the gun with a lacquer thinner. Last edited by piecesparts; 05-11-2008 at 02:48 AM.