Quote:
Originally Posted by bigdon-70blazer
If you want to save the gasket, go inside the cab, get a small diameter like one fourth inch cord or rope. Start at top behind mirror, take screwdriver and pry the rubber enough to put piece of the cord there, then repeat the process untill the entire top edge has cord stuck in behind it. The pry the edge of both corners and get some cordbehind there also and continue down both edges, before you get to the bottom you will notice the windshield starting to get loose, now you can apply pressure to the top and push wind shield forward thru the openning. This will save the gasket which I was told was very important because the new gaskets do not lay down well. Don
|
Thanks for the tip. May try this before cutting as seal looks good as is.