[19673ontree]

I thought about this and here is what I did

#1 I waited till I had my truck painted wet sanded and buffed (DONE)
#2 I screwed the speed nut's up on the peg's of the emblem's a couple time's to make the thread's (NEW EMBLEM'S)
#3 I took a drill and correct size drill bit and drilled away the paint from the emblem hole's on the fender's
#4 I put JB weld on the peg's pushed the emblem's in place put a peice of tape on them to hold them till the JB weld dryed ,
#5 removed tape next day
that was two year's ago and have never had a problem , when I need them of for another paint job I will just heat up the JB weld with a propane torch and remove the emblems , then put them back on the same way again ,

I figured this out on my 67 camaro because rubber man could not get in there to put those nut's on with the fender installed , so this trick work's great dosen't hurt anything and let's you bolt your fender's up align them without having to take them back off to put the emblem's on ,,,,,,,