Quote:
Originally Posted by tk-mpl
Do you have a pic of the 6.2L intake setup yet?? Is there any mods to make the intakes fit?
Thanx.
|
none yet, no mods other then makeing a mounting bracket to support the weight of the tube/air filter....
Quote:
Originally Posted by Ackattack
how does it work with the ride height sensors? Does it try to adjust for body roll while going around a corner?
|
yes, it sences the height of the suspension at any given time or load and adjusts it to your pre-sets....
some progress,
got the tranny lines mocked-up, on the 6l80e they come out of the driver side (unlike the 4l60e)...they are routed tightly under the tranny and then terminate into a AN tube adaptor....from there its just a few 90* and streight fittings, with bradided -6 line........
also doing the wiring, GM keeps switching PCM pins on me, so for all doing a swap 05-06 E38 computers are adiffrent from 07-08 38 computers... (computers are the same, just the pins that connect the wires to the PCM are diffrent) so i got some 07 E38 PCM pins comming...
here is the orginized mess
and a sneek peak at this
