[jonzcustomshop]

I am finally getting the cab welded up.
I have one footwell left to go, and for some reason I have been trying to save the data tag. I should probably just pull it and hang it on the wall before it gets messed up.
some how I screwed up the measurement across the back of the cab, so I had to cut a filler piece off the scrap I had cut out; this is why it is good to hang on to all your scraps until the project is done.
I had to make a couple relief cuts on the corners to get them lined up.
I also had to do a little extra work on the driver rear corner, because I dropped it when I was putting it up on jackstands!
You can also see a little more of the finished (90%) door.