The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Need plug wire/exhaust manifold advice....

**COBALT** · 02-05-2003, 02:46 PM

I think "Under Header Loom Kit" would be the only one I could use here if I went with Moroso. Those manifolds I have wipe out any chance to run the plug wires straight up from the plugs to the distributor. I'll have to run them below, and loop the wires around the back of the engine like they have in the pic.

...which leads me to the next question. What plug wires should I use? Crazy: you use 90 degree plug wires you said. So you have 90 degree boots on both ends of the wires??? The reason I ask is that's the only way to get enough slack to run them from the distributor around the back of the motor like in the pic...

02-05-2003, 02:46 PM	#3
COBALT Senior Member Join Date: Sep 2001 Location: Seattle, WA, USA Posts: 5,817	I think "Under Header Loom Kit" would be the only one I could use here if I went with Moroso. Those manifolds I have wipe out any chance to run the plug wires straight up from the plugs to the distributor. I'll have to run them below, and loop the wires around the back of the engine like they have in the pic. ...which leads me to the next question. What plug wires should I use? Crazy: you use 90 degree plug wires you said. So you have 90 degree boots on both ends of the wires??? The reason I ask is that's the only way to get enough slack to run them from the distributor around the back of the motor like in the pic... __________________ '69 3/4 ton C20 2wd-350ci/TH400 '69 3/4 ton Custom 20 2wd-350ci/4sp Manual '99 2wd 5.7 Chevy Tahoe Seattle, WA.