The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Need plug wire/exhaust manifold advice....

fatfords · 02-05-2003, 03:13 PM

Cobalt,
I saw a truck that used the "universal loom kit" shown on the Moroso page, one set per side. The guy said they were ~$8 per kit. He had a small block with an HEI and used plug wires from a '75 one ton with a 454. That got him the HEI 90 degree boot at the distributor, straight ends at the plugs and long wires. The univeresal loom held the wire so that it would loop around the manifold and route straight into the plug. It looked very organized and he said the wires were less than $20 also. You might look into a pre-HEI big block wire set.

Good Luck,
Kent

02-05-2003, 03:13 PM	#6
fatfords Registered User Join Date: Sep 2002 Location: DFW, TX Posts: 350	Cobalt, I saw a truck that used the "universal loom kit" shown on the Moroso page, one set per side. The guy said they were ~$8 per kit. He had a small block with an HEI and used plug wires from a '75 one ton with a 454. That got him the HEI 90 degree boot at the distributor, straight ends at the plugs and long wires. The univeresal loom held the wire so that it would loop around the manifold and route straight into the plug. It looked very organized and he said the wires were less than $20 also. You might look into a pre-HEI big block wire set. Good Luck, Kent __________________ '56 F-100 (w/all GM stuff) Lookin' for another parts chaser! '05 GMC crew cab