The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

neonlarry · 03-24-2002, 10:52 PM

The channel part is easy. When I did mine the hardest part is getting the old stuff out. For some reason on mine the division bar felt fits so tight on the window that you can't roll it up with one hand. I bought the stuff from early classic enterprises, and other than the one problem it was pretty good. I don't know if I would buy the division bar felt from them though. I saw one that was done with parts from JC whitney, and that actually worked better than the stuff I used and and it was a lot cheaper.

03-24-2002, 10:52 PM	#3
neonlarry Registered User Join Date: Feb 2002 Location: Vacaville, CA Posts: 2,745	The channel part is easy. When I did mine the hardest part is getting the old stuff out. For some reason on mine the division bar felt fits so tight on the window that you can't roll it up with one hand. I bought the stuff from early classic enterprises, and other than the one problem it was pretty good. I don't know if I would buy the division bar felt from them though. I saw one that was done with parts from JC whitney, and that actually worked better than the stuff I used and and it was a lot cheaper. __________________ 70 C/10 Light Red 350/TH350, HEI, Duals w/40 series Flows, 91 seat, LED taillights 99 Pontiac S/C GTP, SLP Ram Air hood, GMPP Konis & springs 95 Neon ACR, MP PCM, AFX UDP, 3.0 CAI