[bguild]

I think I plan to run a 265/35/22 tire.. 29.3 inches.. I dont really care about laying frame but I would like to get it a few inches from the ground. I am planning on some day putting in the engine crossmember I think you guys sell but not right away and I think laying frame will look goofy without getting the front low.. I want a bit of a rake with the front lower than the rear but I also want the rear 22's to tuck.. I am going t o run 20's in the front. i actually plan to do the engine crossmember and rack and pinion after I rag out the current 350 that is in it now. I then plan to put in a ls1 when so i can do it all at once.. I just want to figure out the best way to do the driveshaft. Thanks for any help.