View Single Post
Old 08-02-2008, 11:10 PM   #2
prg machine
Registered User
 
prg machine's Avatar
 
Join Date: Jun 2007
Location: oregon
Posts: 1,069
Re: NP 205 won't go into low range all of the way

I feel realy dumb! I went out there about a half hor after posting this and couldn't for the life of me figure out what could have hurt that 205 transfercase...the things are beasts!

As it turns out this is the first time I went to engage it today to pull against the tree with and I discovered that the lever couldn't travel fully to get full engagement because of the boot that i didn't account for when i mounted it after the trucks floor mat was put in............
works just fine after i pulled the screws out that hold the boot down!!!

I am emberaced!

I wish all fixes were this easy................maybe my blunder wil help someone else.
__________________
69 K-20 cloned to a 67 with front clip and some other stuff.
383 .040 over
Crane roller cam lifters and rockers ,1.6 intake ratio, Open chamber heads, 9.5-1 compression ratio, 2.02 intake valves , Edelbrock performer Air Gap manifold Carter AFB performer 750cfm, MSD ignition, SM465 NP205 4.10 gears:
prg machine is offline   Reply With Quote