here's some pics. Yeah it's super dirty, been sitting on the ground for about 10 months with no washing.
These are from my front end. Same arch though, just a factory size
you can see I retained the 'beauty line' on the lower edge of the wheel well lip. Alot of repop parts don't have that line...
here's a pic of the passenger side, looking back.
you can see the lip I made that goes in, with none of the 'fangs'.
That lip was trimmed about 1/4" off in this picture. It is about 1/2" deep from the inside of the beauty line.
the bigger that inside lip is, the more strength the panel will have.
I think I will make that lip about 1" deep, and if needed it could be trimmed back to suit the specific install.
Having a 1" lip there would be a great place to install inner wells.
I'm thinking inners like on modern trucks, a strong flexible plastic.
But Fenders first, inners down the road if there's enough interest in fenders