Thanks i will give that a try. One of the zerks refused to take grease, so i removed it & found that the zerk is ok. The joint may be rusted or corroded so bad that grease can't get in there. It's the knuckle on the pass side from the frame to the tie rod, so it could be part of the prob. Couldn't get it on the lift today.....hoping for 2morrow.
RD
Quote:
Originally Posted by 68GMCCustom
a) if the draglink assembly is hanging too low it will rub on the crossmember...tighten up the pitman arm further?
b) if someone "over-adjusted" the ps gearbox...it can get tight at high center. Loosen the nut, back off the screw a 1/2 turn or so, tighten the nut back down and see what happens.
thats all I got.
|