|
Re: Inline 6 cyl club members
LHM, it's also BLACK!
I have a 250 and 3 speed in mine.You are probably wanting to reduce the rpm's while cruising.Most of the old 6's were geared for hauling and have low(higher numerically) rear gears.Taller tires will help but a gear ratio may be needed to get what you are looking for.With the 3:73's I run close to 3000 rpm at 60 .Modern drivetrains run about 2000 at 70.You are probably noticing the difference.
If you are having tranny's go bad you may have other problems.
__________________
The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion.
You can't fix stupid,not even with duct tape.
"My appearance is due to the fact that "GOD" does punish you for having too much fun!"
Barrett-Jackson has perfected alchemy,they make rust into gold!
"You can lead a horse to water but you can't saddle a duck"
"Cleverly disguised as a 'Responsible Adult'
"Sometimes your Knight in shining armor is just a retard in tinfoil"
Last edited by PanelDeland; 08-21-2008 at 09:44 PM.
|