The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

zombiescustoms · 09-03-2008, 05:19 PM

I think what I can do is use the 1/2 ton arms (aftermarket) with the 3/4 ton balljoints, if what I have found is correct the ball joint taper and stem are larger on the 3/4 but the outer diameter of the area that presses into the arm is the same.

09-03-2008, 05:19 PM	#8
zombiescustoms Registered User Join Date: Mar 2008 Location: Abingdon, MD Posts: 74	Re: Tubular control arms for 3/4 burb I think what I can do is use the 1/2 ton arms (aftermarket) with the 3/4 ton balljoints, if what I have found is correct the ball joint taper and stem are larger on the 3/4 but the outer diameter of the area that presses into the arm is the same.