[PanelDeland]

Metric left,'mellican right,drives in da middle.I do have terminal ends with my crimper,it's a small box just big enough for the terminal ends,crimper,multi-meter and a couple of screwdrivers.I find it's easier than 3-4 trips to the box.I have an old homeowner Craftsman with files,saws,hole saws,chisels,you get the picture.
I do keep a carry box with the drill and common bits (for the same reason as the crimpers).
A lot of stuff is in the original carry box but grouped by type(pullers,ball joint press....)(body hammers and dollies,slapping spoon(wish I knew how to use some of this stuff).
I keep a carry box with my grinder and wrenches for it,usually has a wheel or two in it but generally keep most supplies in cabinets.I have an 8 ft wall with 3 single door kitchen cabinets,and a 4 drawer (Base).Over the end cabs are upper cabs 2 ft each and pegboard between.I keep clawhammer and screwdrivers pliers and tape measure on the pegs for quick stuff.I also have a small shelf I made for the peg with replaceable ply box to hold the tubes of sealers and such(I hate when that crap gets on my tools).I also have 2 3X2X 5 ft high shelf units for some of the carry boxes and buckets of detail stuff and carwash supplies.