The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

KEH · 02-15-2003, 04:18 PM

I'm not sure which bolts I have to attach the pressure plate to flywheel. (This project has been siiting for 10 years). The Chevy dealer doesn't have any in stock either. The only 6 that I have alike is in the pic below. Is this the correct bolt?

Also, any installation tips would be appreciated. With the non-threaded shank do I just tighten until they bottom out?
It's been a few years, and I want to make sure I get it in right.

Thanks for the help..

02-15-2003, 04:18 PM	#1
KEH Better late than never Join Date: Dec 2001 Location: Columbus, IN Posts: 324	HELP, Pressure plate to flywheel bolt I'm not sure which bolts I have to attach the pressure plate to flywheel. (This project has been siiting for 10 years). The Chevy dealer doesn't have any in stock either. The only 6 that I have alike is in the pic below. Is this the correct bolt? Also, any installation tips would be appreciated. With the non-threaded shank do I just tighten until they bottom out? It's been a few years, and I want to make sure I get it in right. Thanks for the help.. __________________ 1970 C/10 SWB Stepside