Quote:
Originally Posted by kizer
No I wasn't truely implying that I wanted to run coils I was just trying to get a base for how much drop would be gained by just bolting on the new cross member.
So just from your reply it would stand to say that by adding the new drop spindles if they are 2-inch drop and moving the pivot points up 3 inches you could be looking at roughly 5 inches of drop.
|
Kizer-
As SCOTI mentioned it's gonna drop you right between the 2-3 inch mark by doing a direct bolt-in. There's a few factors that make it difficult to get an exact measurement on this, but that should be close enough.
I can get you measurements of where it will sit at ride height and dump height once installed... just let me know the tire size, and I can tell you where the bottom edge of the frame (under the cab) will sit in reference to the ground. If it's a short tire, you might not need to purchase drop-spindles.
Nate