[madaca]

I will check that tomorrow and see what I come up with. I know the gasket is seated properly but I need to look at it and find out what is causing air to seep out of that bolt hole. I am sitting here looking at the diagram that came with the carb kit and just noticed that I did something wrong. The two little balls that come with the kit (one is smaller than the other)....well I put the larger one in the pump intake but the diagram shows that it should be the small one. I also did not notice I was supposed to put the larger ball in the pump discharge hole with the spring and retainer. I completely forgot to put that larger ball in there. I do not know what exactly they do but I will be fixing that tomorrow. Other than that, everything else is good. I just need to figure out this air coming out of that bolt hole.