View Single Post
Old 11-04-2008, 09:51 PM   #1
lyrikz
PITbut
 
lyrikz's Avatar
 
Join Date: Sep 2007
Location: monroe washington
Posts: 3,055
Im at my wits end here with door alignment.

Im really at my end here. This door is goign to be the damn DEATH of me...

I can NOT get it to align. The top upper left corner touches and the upper right where it curves down is sitting about 3/4 of an inch to low.

My questions are this.
Can that door frame be bent? Can i remove the spot welds at the bottom right corner of the post and pull the post up a bit and reweld it???

ANY tips to getting the door to align would be appreciated.. here is another pic... Also, the hinges were pretty bad so i replaced them. Nice and firm now.
lyrikz is offline   Reply With Quote