The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

The Big Green · 11-14-2008, 08:26 PM

I'm want to lay out in the front, but what's needed? I will more than likely run a 20in wheel up front, 255/35/20. I want a cheaper way out, I'm guessing just a 3in Z, and a 3in spindle? I could use a little help, I'm new at this, but try to read up all I can. I can't really afford a dropmember, because they are nomally like a couple grand. There was a guy, on here, that cut enough off his stock front crossmember, and I think he could lay. Just wondering what would be the best way, thats fairly cheap?

11-14-2008, 08:26 PM	#1
The Big Green Registered User Join Date: Oct 2007 Location: Fort Smith,AR Posts: 1,304	Cheapest way to lay in front, need help. I'm want to lay out in the front, but what's needed? I will more than likely run a 20in wheel up front, 255/35/20. I want a cheaper way out, I'm guessing just a 3in Z, and a 3in spindle? I could use a little help, I'm new at this, but try to read up all I can. I can't really afford a dropmember, because they are nomally like a couple grand. There was a guy, on here, that cut enough off his stock front crossmember, and I think he could lay. Just wondering what would be the best way, thats fairly cheap?