The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Motor Mount Question 73-87 X-Member on 69 frame

GlennBrittain · 12-08-2008, 02:42 PM

I am back in Galveston County now, where I have internet service. I did the search thing before I started on my frame. I found that FAQ's on the x-member and motor mounts. I also found a post that said there were different x-member heights in this truck era. I deciced to bolt everything up drill the required holes as I progressed due to that post.
I will be going back to the Piney Woods in a week or so hope to get a motor and trany bolted up then. I need to order a trany cross member if anyone knows which one works best. I lost all of my Copperhead recordings, one was shown on a episode I had recorded.

12-08-2008, 02:42 PM	#9
GlennBrittain Senior Member Join Date: Jun 2003 Location: Panola County Texas Posts: 401	Re: Motor Mount Question 73-87 X-Member on 69 frame I am back in Galveston County now, where I have internet service. I did the search thing before I started on my frame. I found that FAQ's on the x-member and motor mounts. I also found a post that said there were different x-member heights in this truck era. I deciced to bolt everything up drill the required holes as I progressed due to that post. I will be going back to the Piney Woods in a week or so hope to get a motor and trany bolted up then. I need to order a trany cross member if anyone knows which one works best. I lost all of my Copperhead recordings, one was shown on a episode I had recorded.