The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

cparman · 01-31-2009, 03:24 PM

I bought a set of Taylor wires also. They are 90 degree at the spark plug. I ran the front two on each side between the motor mount and engine block, then made a little bracket to hold them near the oil pan rail. the rear two on each side have a plug wire separator on them. Then finished each end at the HEI. The distributor ends can be a bear to slip over the wire. I used a bit of liquid soap on the boot and the wire to help with this. They are nice and neat, look great

01-31-2009, 03:24 PM	#4
cparman sharp as a marble Join Date: Jan 2007 Location: atlantic beach,florida Posts: 1,082	Re: Spark Plug Wire Help? I bought a set of Taylor wires also. They are 90 degree at the spark plug. I ran the front two on each side between the motor mount and engine block, then made a little bracket to hold them near the oil pan rail. the rear two on each side have a plug wire separator on them. Then finished each end at the HEI. The distributor ends can be a bear to slip over the wire. I used a bit of liquid soap on the boot and the wire to help with this. They are nice and neat, look great