|
Re: Tips Needed: Clutch Install
Take the time and have your flywheel resurfaced before installing the clutch. Its a time consuming job if its your first time. Just disconnect the Battery, remove the starter, Drive shaft, crossmember ( if you have one), clutch linkage, 4 bolts for trans, the 8 or so on the bell housing. Then the clutch and then flywheel. If you have an old yoke stick it in the rear of the trans so you dont get gear oil everywhere. Also change the pilot bearing in the end of the crank. then reverse the process and go go go. Good luck. Ive got 2 flywheels so I keep one surfaced so I have done the turn around in about 4 or 5 hrs.
__________________
1968 chevy shortbed, Dark Shadow Gray
4 bolt 383 Stroker,Weiand Super Charger, disc brakes, 9 inch, 391 gear, 20" Eagle wheels, muncie 4 speed/ Hurst shifter, 4/7 drop, Hedman midlengths, 3 inch exhaust w/ 2 chamber flows. 1966 Mustang with 306 roller, c-4, 9 inch Detroit locker rear. 1965 Fastback Mustang w/347 stroker, top loader 4spd, 9 inch detroit locker. 1966 Mustang coup, 306 roller, c4, 9 inch. 65 Cobra, 427, T6oo, 9inch, of course. First gen Hayabusa, airbox mod and running 2 exhaust cams.. Zoom Zoom Zoom
|