The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Wrenchbender Ret · 02-04-2009, 07:10 PM

You didnt say weather it is a 3 speed or 4 speed. I gather its 67-72. You dont have to pull the bell housing on these. Just pull the trans. out & remove the clutch from out the bottom of the housing. Then you can pull the flywheel out too if you are going to have it surfaced. Sometimes the flywheel wont quite clear. You can grind a little groove in the houseing to get it out. With a 3 speed this is the easiest clutch job you will ever do.

02-04-2009, 07:10 PM	#8
Wrenchbender Ret Registered User Join Date: Oct 2005 Location: Overland Park, Ks. Posts: 5,229	Re: Tips Needed: Clutch Install You didnt say weather it is a 3 speed or 4 speed. I gather its 67-72. You dont have to pull the bell housing on these. Just pull the trans. out & remove the clutch from out the bottom of the housing. Then you can pull the flywheel out too if you are going to have it surfaced. Sometimes the flywheel wont quite clear. You can grind a little groove in the houseing to get it out. With a 3 speed this is the easiest clutch job you will ever do.